They are commonly found in mobile homes covered with rubber are used usually in flat roofs. These roofs are simple and easy to install, in comparison to the roofs of rock or metal. How can have other roof skylights add light to your home. Rubber roof with existing installation of skylights is as simple as working on the skylight. With appropriate instructions and various instruments new rubber roof can be installed in some time.
1 measure the size of the roof to determine the total area is included. Multiply the width by the height of this problem. Sweeping roof cleaned to remove any Earth and debris found in the envelope. Background right around the area containing the skylight make sure nothing is on the road.
Roll 2 rubber roof rooftop skylights set. Measure the light blue and mark on the reel of the pool of natural rubber. Cut with a knife and adjust if the skylight above. Continue until all the roofs was developed.
3. permission to wait a few minutes; and then roll in half only half of the roof is covered by a roof. Pour the concrete roof in the roof near the roof and rubber rollers start with large paintings. Distributed throughout the region until it was all.
4 Shooting in the first page of coatings, to ensure that it matches the opening above the upper limit of skylight. It would be anywhere in the ceiling to produce bubbles that may be behind him. Smooth on any surface and pick up through the roof.
5 to paste to the other side as well as in the previous step. Roll roofing on glue and could result in each location to ensure compliance with the ceiling. Application of silicone adhesive around the skylight base valve to ensure that it properly near the ceiling. Discover everything you want to check and verify that all points of the bubble has been installed correctly.
No comments:
Post a Comment